Estate Swing Manuál s instrukcemi stáhnout pdf (Strana 41)

Control Board LED Lights - The control board LED lights are located above their respec-

tive terminals that they represent. (With exception of ALIM, power supply light, which is located

below the power terminals in the upper left corner.) The LED lights are a quick way of verifying

necessary connections are made. Below is a chart of their interpretations.

LED Lights & Operational Displays

LED ON OFF

ALIM Powers supply by transformer Power supply by battery or no power

FCC 1 Motor 1 closing limit switch - not tripped Motor 1 closing limit switch - tripped

FCA 1 Motor 1 opening limit switch - not tripped Motor 1 opening limit switch - tripped

FCC 2 Motor 2 closing limit switch - not tripped Motor 2 closing limit switch - tripped

FCA2 Motor 2 opening limit switch - not tripped Motor 2 opening limit switch - tripped

STOP Stop command - not activated Stop command - activated

FSW CL Closing safety device - not tripped Closing safety device - tripped

FSW OP Opening safety device - not tripped Opening safety device - tripped

During idle (closed and waiting on command) for single gate openers, all should be on ex-

cept FCC1, FCC 2, and FCA 2.

During idle for dual gate openers, all LED lights should be on except for FCC1 and FCC2.

If not using safety devices , you must jump STOP, FSW CL and FSW OP to COM in order

for the gate opener to function.

Standard Operation Display - This is when the gate opener is not in parameter setting

mode or programming mode. LED displays DS1 and DS2 will show the following:

Gate Status

Gate At Rest in Closed Position

Gate Opening or Gate Open when Auto Close is OFF

Gate open in pause status

(Only with automatic re-close enabled - Parameter c)

Gate Closing

5.1

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Žádné komentáře

Estate Swing Manuál s instrukcemi Strana 41